Some clubs will reduce their mowing heights further, perhaps down to 3mm to help speed up the greens for club competitions. Prolonged mowing at these heights will lead to plant stress.

The speed of greens can be affected by other factors - too much thatch is the main cause of slow greens, or the fact that the greens have not had enough topdressings to maintain levels.

Many bowlers complain about slow, inconsistent greens, often resulting in many clubs trying to speed them up by shaving off more grass. In the short term, this may increase speed but, in the long term, it will be very damaging to the green.

• Remove and control the rate of unwanted vegetative growth (thatch and side growth) by regular grooming and verticutting operations.
• Light applications of topdressing will restore and maintain surface levels, thus increasing green speed.
• Mowing in several directions to reduce nap layering will help increase green speed.
• Double cutting for matches will increase green speed.
• Controlling soil moisture will help influence green speed.
• Brushing/switching of the playing surface keeps the green clean and removes any dew or surface water. Keeping the surface dry will improve resistance to disease.

Mowing. Too many bowls clubs choose to cut their greens far too low during the summer months, mainly influenced by club members who want faster greens. Do not be tempted to cut below 4mm unless you have the expertise, resources and knowledge to support this type of maintenance regime. Mowing the green below 4mm will, in the short term, give the members what they want - fast greens - however, there is often a cost to bear for doing this. It generally comes in the form of the green suffering in many ways, grass cover begins to thin out, bare areas develop which allow weeds and mosses to establish. Beneath the surface, the constant rolling will have compacted the soil profile, reducing the air spaces. This leads to poorer root growth, less movement of water and resulting in flooded surfaces.

In fact, the most common cause of slow bowling greens is the presence of a layer of accumulated organic fibre, commonly known as thatch. This is found just below the surface and is caused by the accumulation of matted grass stems. This is easily detectable when you walk across the green and the surface feels soft.

Aeration is a key activity to ensure that there is a good air/gas exchange going on in the soil profile. The use of a sarel roller (depth 5mm) helps to keep the surface open without disturbing the playing surface. Deeper aeration should only be done with micro tines when moist conditions allow penetration.

Irrigation. Water is influential in all chemical, physiological and biological processes of plant growth. The soil/plant water relationships is critical to the sustainability of any grass plant. Having an understanding of these relationships is critical. All grass plants are a continuum of water movement. Over 90% of the plant's water requirements are transported through the plant from the soil profile, via the roots and stem tissues into the leaves and out into the atmosphere. Knowledge of these relationships is important when designing and operating irrigation systems. The main aim is to achieve a water balance within the soil profile ensuring that the grass plant is able to access available water from the soil.

Irrigation scheduling by the water balance approach is based on estimating the soil water content. In the field, daily evapotranspiration (ET) amounts are withdrawn from storage in the soil profile. Any rainfall or irrigation are added to storage. Should the water balance calculations project soil water to drop below some minimum level, irrigation is indicated. Weather forecasts enable prediction of ET rates and projection of soil water balance to indicate whether irrigation is needed in the near future.

The soil water balance will be affected by a number of factors:

• Soil type and condition; the water holding capacity of soils will vary depending on their classification. Clay soils can hold more water than loamy or sandy soils, therefore soil type will effect and contribute to the amount of water required. Soils are continually going through phases of wetting and drying caused by local weather conditions.
• Turf type and condition; healthy vigorous turf will transpire more water than an unhealthy turf plant.
• Time of the year; there is likely to be more soil water present during the spring, autumn and winter months when temperatures are cooler coupled with higher levels of rainfall.
• Weather; air temperature, daylight hours, solar energy inputs, wind speed and shading are factors that will affect evapotranspiration rates.
• Maintenance regimes; keeping the soil open and aerated will increase the drainage capacity of the soil. On the other hand compacted soils will prevent the movement of water through soils, often creating an environment that prevents water getting down into the soil profile. By carrying out effective regular maintenance regimes that include aeration, scarifying, harrowing, brushing, top dressing all help to keep the soil in good condition.
• Irrigation system; type, capacity, running time, calibration and efficiency.
• Water resources; quantity and quality. The quantity of water available, and the amount licensed for use in any one year, will determine the performance of any system and irrigation capabilities.
• Facility type; design and construction. USGA greens perform differently to pushed up soil greens, each having different water and management requirements. Modern drainage systems also effect soil water conditions. Extensive drainage systems will freely drain water from the soil.
• Groundsman knowledge; it is important that there is someone who understands all of the above parameters and can access the water requirements of the turf and correctly implement the right irrigation schedule for the facility.

Soil water relationships are key drivers in maintaining plant health, so it is vitally important you readily water your bowling green and ensure the plant does not become stressed from the lack of water, on the other hand you do not want to be over watering, as this may bring you other problems.

Fertilising. Fertiliser treatment and turf tonics can be continued in accordance with your annual programme. If you haven't got a fertiliser programme, have your soil tested; try an independent soil analysis company for an impartial set of results.

A regular feeding programme is essential to maintain colour, vigour and well-being of the sward. A combination of a slow release granular based fertiliser, topped up with some organics/liquid feeds, are becoming a popular method of feeding bowling greens. The slow release will generally last around three months, whilst the liquids can be applied every 4-6 weeks depending on the plant's needs.

The use of wetting agents are a good preventative cure for dry patch. Many groundsmen are now using these products regularly on fine turf situations. Wetting agents are usually applied on a monthly basis.

Soil wetting agents are available in three forms - Residual, Penetrant and Curative.

Residuals keep working over a given stated period, depending on the amount of time you require it to work they hold water near the surface.

Curatives combat the problem of dry patch by stripping off the waxy organic coating on the soil particle which renders the soil profile water repellent, but never totally alleviates the problem as, every time you topdress with sand, you add a further layer of water repellent organic coating to your soil profile. This type of wetting agent is believed by some to also remove beneficial bacteria etc from the soil and therefore can be controversial. One of the lesser known facts is that when using curatives your water consumption can reduce by up to 30% year on year. Product example Correct Oars by Vitax.

Penetrants help remove standing water as well as move water through the profile. Many turf managers use penetrants in a tank mix, when using other chemicals to get the product through the profile immediately.

To achieve the best from wetting agents any factors contributing to the dry patch should be addressed. Such as alleviation of compaction, removal of thatch and preventing the rootzone from reaching the critical moisture content by ensuring even and timely irrigation.

Best results are achieved by applying wetting agents in a programmed approach, starting early in the season before symptoms are observed. Blanket applications are also more effective than spot treatments.

Generally, you should be looking at a programme of scarifying in several directions to remove unwanted thatch layers and dead matter, aerating with some deep solid tines to break up compaction, topdressing with some 70-30 topdressing to restore levels, and overseeding with some new grass seed.

Unfortunately, one of the deciding factors that often reduces the effectiveness of these planned works is the amount of money (budget ) the club has available. It can cost anything between £1200-£1500 for a contractor to come in and do all the work.

Savings can be made if the club undertake the work themselves, however, the effectiveness of the work carried out will be determined by the equipment they have at their disposal.

Savings can also be made if clubs buy materials in bulk (several clubs group buying).

The best way to balance the health of the grass plant and to achieve good green speed is to promote and carry out effective cultural practices.